10
10˝ DRILL PRESS
ENG
ADDITIONAL SAFETY
INSTRUCTIONS FOR DRILL PRESS
For Your Own Safety Read Instruction Manual
Before Operating Tool
a) Wear eye protection.
b) Do not wear gloves, necktie, or loose clothing.
c) Clamp workpiece or brace against column to prevent
rotation.
d) Use recommended speed for drill accessory and
workpiece material.
SAVE THESE INSTRUCTIONS
SYMBOLS
Read the manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
n
o
No-load speed
TECHNICAL DATA
Voltage
120 V-60 Hz
Amps
6.2 A
Rated speed
620-3100/min
Swing 10˝
Spindle travel
2˝
Table size
8˝ x 6-1/2˝
Throat depth
4-15/16˝
Table bevel range
0-45
o
Left & Right
Speed settings
5
Weight
48.3 lbs
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the instruction
book carefully.
WARNING:
To prevent personal injury, do not
connect the machine to the power source until
the machine is completely assembled and you have read
and understand the entire instruction manual. Always
disconnect the plug from the power source before
assembling parts, making adjustments or changing drill
bits.
ASSEMBLY
1. ASSEMBLY OF MACHINE BASE/COLUMN
1) Position Machine Base on floor (See Fig.A)
Remove protective sleeve from Column tube and
discard. Place Column assembly onto Machine Base,
and align holes on the Column support with holes on
the Base.
Install a bolt in each hole (through Column support
and Base) and tighten the Fixing Bolts (8) with
adjustable wrench.
2. ASSEMBLY OF THE TABLE CRANK
1) Locate the Elevation Worm Gear and the Table Crank
(need new reference image). Insert the Worm Gear
into the Table Crank so when you turn the handle the
gear properly rotates. Then loosen the set-screws on
the back of the Table Crank so it may easily fit over the
Column (reference C in image B).
2) Remove the Collar from the Column. The long smooth
end of the Column should be the top.
3) Place the Raising Rack on the right side of the Column
(from a front perspective) and ensure that the bottom
of the Rack is aligned inside the flange on the base
of the Column. While holding Rack, slide the Table
