English
1
Use the fuel gauge to check if the fuel is suf-
ficiently filled up in the tank.
If ignition fails, try again its procedures
as follows
Stop completely the operation. The operat-
ing lamp has turned off, then try again the
procedures.
3-2. Operating Procedures
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
■
Ignition Procedures
• When smell, smoke, wrong burning, etc. takes place, stop immediately operation to avoid
a fire, and contact your dealer.
• If the heater does not ignite with three consecutive tries, stop trying more than three (3)
times, to avoid a fire, and contact your dealer.
• When using the heater, be careful so that the floor surface (in front of it ) may not get
overheated.
• Do not operate the heater, while fuel tank is dirty and foul, to prevent poor ignition or
wrong burning.
CAUTION
Observations
• Not to miss the ignition, please do not leave the heater until you confirm that it is properly burning.
2
Turn “
ON
” the operating switch, and the oper-
ating lamp will light and the heater will ignite
in about 5 seconds.
Adjust the angle of the main unit
Loosen the knob bolt to move and set the
main heater unit at the desired angle, and
tighten the knob bolt firmly.
The vertical angle of the radiation disk is ad-
justable up to 20 degrees upward.
Loosen
Tighten
20 degrees
• Do not adjust the angle of the main unit while the heater is plugged in operating or hot to
avoid sever burns and electric shock.
CAUTION
7
Operating Switch “
ON
”
RU N
M I S F I R E
O F F
O N
