3D Printer User Manual
www.shining3d.com
47
Phenomenon: The 3d printer screen show “ no SD card”.
Solution: (1) Use English and Arabic numerals name the .gsd file.
(2) Pull out or plug in SD card when the printer power off.
Reason: (1) Einstart DP 3D printer can’t read the .gsd file named by Chinese
word,and it only show 6 characters add number if the name above 8
characters.
(2) Pull out or plug in SD card when the power on will cause the 3d printer
can’t identify the SD card.
8.7. The extruder is blocked or forming cottony filament during printing the
model, or the model is dislocated.
Solution: (1) Clean the filament and check whether the nozzle is blocked.
(2) load filament again.
(3)shut down the printer and check whether the X axis and Y axis an move
normally.
(4) Print model again to to determine the exact problem.
Reason: (1) the poor quality filament will cause the extruder blocked.
(2)The nozzle run into the model cause the printing dislocated.
(3)The nozzle is blocked.
(4) The temperature sensor is broken.
(5)The cooling fan can’t move.
8.8. Limit switch broken
Phenomenon: it starts to make loudknocking noise after open the printer for some
springs on limit switch is broken.
Solution: Change limit switch (Refer to the video and document).
Reason: The limit switch was broken by mistake when clean the remaining filament or
damaged during transport.
8.9. The wire of power is poor connect
Phenomenon: The light of power adapter isn't work after applied power, or the power
is shut down for the plug is touched lightly.
Solution: Try to update firmware again or change power adapter(24V/80W).
Reason: Update firmware failure, or the wire of power is poor connect.
