3D Printer User Manual
www.shining3d.com
32
6. Print setting references
6.1. Path generator setting
Figure 6.1
Usually, only “Print mode” needs to be adjusted. It is best to use the defaulted
setting to print, or the extruder might be blocked.
There are 5 options to set the print accuracy between 0.1mm to 0.4mm per layer.
The finer the layer, the better the quality, the stronger the printed part and the longer it
takes to print.
MODE_Simple:0.4mm layer thickness
；
MODE_Fast:0.3mm layer thickness
；
MODE_standard:0.2mm layer thickness
；
MODE-Quality:0.15mm layer thickness
；
MODE-Extreme:0.1mm layer thickness
；
Support Mode:
None support:There is no support generated.
Outside support:The support will be generated outside on the raft
Full support:There will be outside and internal support generated.
