Shindaiwa DGW400DM-C, Owner'S And Operator'S Manual

Page: 39 / 48

- 36 -
<<<<
Note
>>>>
•
Secure the drain valve body using a spanner or similar tool so that it does not
loosen when removing/installing the plug by turning it.
•
It is possible that there is a fuel or oil leak if the drained fluid contains oily
components. If this occurs, check for leakage locations.
•
Although the fluids that can leak internally consist of oil, fuel, cooling water and
battery fluid, the spill containment does not have a function that can separate
rainwater that has leaked into the equipment from these internally leaked fluids.
Properly dispose of liquid drained from the spill containment in a manner according
to the applicable laws and regulations.
(8) Cleaning/Inspecting the Spill Containment
Clean / Inspect Every 400 hours or 1 year
Caution: Injury
•
Always be sure to use the lifting lug when lifting the equipment, and lift
slowly and directly straight above.
•
Wear a helmet, safety shoes, gloves and similar protective gear when
performing lifting work. Do not stand or get under the equipment while it
is suspended.
•
For cleaning/inspecting the spill containment, set this equipment with it
situated on a stable level surface so that it is prevented from moving.
1) Drain the liquid from the spill
containment.
2) Remove the seven installation
bolts (M8) of the spill containment.
3) Lift up the equipment body to
separate the spill containment
and set the equipment on a level
surface.
4) Clean the inside of the spill
containment using a high-pressure
washer or similar equipment.
5) Drain the cleaning liquid from the
spill containment.
6) Remove any rust that has formed
in the spill containment and paint
it again.
Drain Valve Lever
Fixing
Plug
Tighten
Loosen
CLOSE
CLOSE
OPEN
Drain Valve Lever
Drain Valve Lever
Plug (R1/2 ")
Lifting Lug
Spill
Containment
Bolt (M8)
・
Right: 4 bolts
・
Left: 3 bolts