Shindaiwa DGK180F, Owner'S And Operator'S Manual, Page: 51 / 66

48
< Note >

When attaching the Element, check that there is no foreign material adhering to the gasket.

Be careful not to over-tighten the air bleeder plug.

After attaching, be sure to always start the engine and check that there is no fuel leakage.

Always be sure to wipe up any spilled fuel.

Main filter element part no.: 8983129180 (Isuzu part no.)

After replacing the filter, always air out the fuel system.
(Refer to section “
9-3. Procedures during Operation
”.)
(7) Pre Fuel Filter Replacement
Replace Every 500 hours
Place a container under Fuel Filter to catch fuel spilling out
of the filter.
Loosen the air bleeder plug of the fuel filter sufficiently.
Loosen the drain plug on the bottom to drain the fuel.
Remove the outer case of the filter using the specified filter
wrench.
Remove the fuel filter element.
Install a new fuel filter element.
Replace the O-ring of the outer case.
Apply fuel to the each O-ring thinly.
Screw the outer case into the filter by hand until O-ring
contacts to the sealed surface. Fully screw the filter by
special filter wrench.
Tighten the drain plug on the bottom and the air-bleeding plug.
Drain plug tightening torque
2 - 3 N
･
m
Air bleeding plug tightening torque
7.9 - 11.7 N
･
m
Outer case tightening torque
28 - 32 N
･
m
< Note >

When attaching the cup, check that there is no foreign material adhering to the O-ring.

Be careful not to over-tighten the drain plug and air bleeder plug.

After attaching, be sure to always start the engine and check that there is no fuel leakage.

Always be sure to wipe up any spilled fuel.

If water is accumulate in the cup, draining water from the fuel tank and the water separator.

Pre filter element ( Including O-ring ) part no.: 8980742881 (Isuzu part no.)

After replacing the filter, always air out the fuel system.
(Refer to section “
9-3. Procedures during Operation
”.)
1
2
3
4
5
6
7
8
9
10
Pre
Drain Plug
Fuel Filter Element
(Pre)
Outer Case
Air Bleeder
Plug