19
The following are general checkpoints; please call your local Shimpo representative or contact Shimpo Instruments directly for further assistance.
The DRI does not turn on:
• Check all electrical components (power source … battery or power cord)
The DRI does not recognize a sensor:
• Check connection between the DRI and the remote sensor
• Refer to calibration instructions for a sensor that cannot be recognized
Error Codes are displayed:
• If any error codes appear on the display, turn power OFF and then ON
• If error code remains, see table below:
Tr ou b l eshoo t i n g
Ca l i b r a t i on (con t i n ued)
DISPLAY
CONDITION
ACTION
EE PROM reading error
Press RESET; unit will default to
factory settings
Memory data error
Press RESET to clear memory
Calibration error
Press RESET and repeat calibration
procedure
Memory unit error; occurs if the
Change measurement units or clear
measurement unit (lb, Kg, N) is
memory
changed while entering data into
memory
Sensor error; occurs if the remote Change sensor or clear memory
remote sensor is changed during
data entry to memory
Overload condition –possible
Remove excessive load; if the display
load cell damage
does not return to normal operation,
send unit in for repair
MODEL
SELECT NUMBER
DISPLAY
CALIBRATION WEIGHT
LC-50S
06
50L
25kg
LC-100S
07
100L
50kg
LC-200S
08
200L
100kg
LC-500S
10
500L
250kg
TS-3SD, TS-3J
18
t50o
TS-10SD, TS-10J
19
t10L
TS-20SD, TS-20J
20
t20L
TS-50SD, TS-50J
21
t50L
TS-100SD, TS-100J 22
t100L
Please call Shimpo for information on additional sensors.
