3
Se t -Up
Po w e r
Every DRI unit is shipped from the factory without the batteries (provided) installed. To install the batteries:
1. Remove the battery plate located at the bottom of the handle using a coin or appropriate screwdriver.
2. Install the (4) AA batteries, observing the proper polarity.
3. Reinsert the battery plate cover, making sure the lip engages properly before tightening.
NOTE
: If AC adapter operation is preferred, refer to the “Display & Keypad” section of this manual for AC outlet location.
Con nect i on / Discon nect i on o f DRI t o Loa d Ce l ls (LC) o r To r q ue Senso rs (TS)
CAUTION
: Always confirm that the DRI’s power is turned OFF when connecting or disconnecting an LC or TS.
Instructions to connect a remote sensor (LC or TS) are as follows:
1. Remove the plastic cover from the DRI’s remote sensor port.
2. Align the arrows from the remote sensor’s plug with the arrows on the port of the DRI.
3. Push the plug straight onto the port until a “click” is heard.
4. Press the DRI’s ON button; the LCD will briefly display all indicators (see “Display & Keypad” section).
5. The DRI will briefly display what type of remote sensor is connected (“SEN” will be flashing on the small display). The abbreviations
on the main display are as follows. Please call Shimpo for information on additional sensors.
Load Cells (LC)
PART NUMBER
MAIN DISPLAY
LC-50S
50L
LC-100S
100L
LC-200S
200L
LC-500S
500L
Torque Sensors (TS)
PART NUMBER
MAIN DISPLAY
TS -3SD/TS-3J
t50o
TS -10SD/TS-10J
t10L
TS -20SD/TS-20J
t20L
TS -50SD/TS-50J
t50L
TS -100SD/TS-100J
t100L
Instructions to disconnect a remote sensor (LC or TS) are as follows:
1. Press the DRI’s OFF button.
2. Press and hold the gray release button located towards the top of the remote sensor’s plug.
3. Pull the plug (not the cord) straight off the DRI’s port.
4. Connect another remote sensor (see instructions above) or replace the protective plastic cover on the exposed port of the DRI.
