71
4. Parameter description
Parameter
Parameter
Factory
setting
Setting
range
Remarks
0
RUN (Inverter running): Signal will be output when the
output frequency is equal to or higher than the starting
frequency.
40
1
0~15
1
SU (Up to frequency): Signal will be output once the
output frequency has reached within the set region of
the set frequency.
2
FU (Output frequency detection): Signal will be output
once the output frequency has reached or exceeded the
detection frequency set.
3
OL (Overload detection): Signal will be output once the
current limit function is triggered.
85
5
0~15
4
OMD (Zero current detection): If the output current
percentage of the inverter is less than the set value of
P.62, and lasts for the pre-defined time (the setting
value of P.63), OMD will output signal.
5
ALARM (Alarm detection): Alarm detection
6
PO1 (Section detection): In programmed operation
mode, PO1 signal will be output in the end of each
section.
7
PO2 (Periodical detection): In programmed operation
mode, PO2 signal will be output in the end of each
cycle.
129
0
0~15
8
PO3 (Pause detection): In programmed operation mode,
PO3 signal will be output when the inverter pauses.
9
BP (Inverter output): Switch between the inverter
operation and commercial power-supply operation
function, when the inverter operation, BP will output
signal.
10
GP (Commercial power-supply output): Switch
between the inverter operation and commercial
power-supply operation function, when the commercial
power-supply operation, GP will output signal.
11
AUX (Aux output): If multimachine constant pressure
system function selected, when the second water pump
is operating, AUX will output signal.
130
2
0~15
12~15
Please refer to the instruction of control card.
120
0
0.1~3600s
---
PDF created with pdfFactory trial version
