Shibuya Hoppmann L500A V2, Installation & Maintenance Manual

Page: 75 / 92

74 75
LABEL PITCH
The label pitch is the sum of the label length and the gap between the
label and the next label. The pitch can be entered as a parameter.
This can also be done using the LABEL‑TEACH programming which
will determine the exact pitch length and entering the information auto‑
matically.
a
Min Value: 1 (steps); Max Value: 99999 (steps)
a
Default value: 1000
CURRENT REDUCTION
This parameter displays the current reduction setting of the power drive.
Factory set is 255. It is recommended that this value not be changed.
a
Min Value: 0 (select); Max Value: 255 (select)
a
Default value: 255
PRODUCT SENSOR EDGE
Toggles between Lead and Trail detection on the product sensor.
(1) – Trail
(0) – Lead (Default)
Lead – Initiates timing on the leading edge of the product.
Trail – Initiates timing on the trailing edge of the product.
Note: Settings valid if product sensor is set to light operated mode.
a
Min Value: 0 (select); Max Value: 1 (select)
a
Default value: 0
Chapter 5 Operator Interface
UP DOWN +DIGIT
LABEL PITCH
+00000 [steps]
PARAMETER - SETUP
-DIGIT ENTER
+
CURRENT REDUCTION
+255 [Select]
PARAMETER - SETUP
-EXIT ENTER
SCRUP SCRDN
UP DOWN +DIGIT
PRODUCT SENSOR EDGE
+1 [select]
PARAMETER - SETUP
-DIGIT ENTER