Shibuya Hoppmann L500A V2, Installation & Maintenance Manual

Page: 66 / 92

L500A V2 High Speed Labeler Manual
66 67
STOP COMPENSATION
The Stop Compensation sets up the maximum and minimum labeler
speed and measures the label flag change with respect to the peeler tip.
This value compensates for the reaction time of the label sensor and the
controller input.
a
Min Value: 0 (steps); Max Value: 99999 (steps)
a
Default value: 0
How to set up the Stop Compensation:
Step 1.
Feed the labels in ASYNCHRONOUS labeling mode at the lowest re‑
quired labeling speed (less than or equal to 100 Hz). Mark the position
of the labels at the peeler plate.
Step 2.
Dispense labels at the highest labeling speed you want to reach with your
label head.
Step 3.
Determine the offset distance in motor steps. Knowing the mechanical
parameters and gear factors of the labeling head make it possible to cal‑
culate the amount of steps the label is off at high speeds.
Step 4.
Use the highest labeling speed as the compensation speed and the amount
of steps as a stop compensation distance value. Enter this value into the
screen.
Step 5.
This compensation needs to be done only once since it is a fixed machine
parameter. If you change anything in the mechanics or the product sensor,
the stop compensation will need to be set up again.
The stop distance must be long enough to guarantee that the stop com-
pensation works efficiently. To start, place label sensor in the center or
close to the trailing edge of the label.
+
STOP COMPENSATION
+0 [Steps]
PARAMETER - WIPE
-EXIT ENTER
SCRUP SCRDN