shelolab SM10HP-2, Installation And Operation Manual

Page: 18 / 44

18 | P a g e
CONTROL PANEL OVERVIEW
Figure 7: Control Panel and Controller
Power Switch
Labeled Power, this illuminated switch controls all power to the oven. It must be in the On ( I )
illuminated position before any systems are operational.
Set Temperature: The Temperature Display and Controller Unit
The temperature display and controller unit for large capacity SMOHP-2 ovens is a JUMO dTRON.
After booting up, the display shows
the homepage . The homepage shows the current oven
chamber air temperature in red (top), and the current temperature set point in green (bottom). Both
are in degrees Celsius.
Figure 8: Display Home Page
The orange numerical indicators on the lowest level of the display indicate internal communication
processes within the controller and between the controller and the oven. An orange ramp symbol
illuminates when the controller is running a heating profile.
Controller Modes
As shipped from the factory, the controller boots up in its heating profile function mode , ready to
be programed and then launch a profile. While on the home page in heating profile mode, the up
arrow button launches the heating profile, if one has been programed. This button also aborts a
heating profile, if pressed again while the profile is running.
Pressing the down arrow unlocks the green temperature set point when a profile is not running.
Both arrow keys can then be used to adjust the unlocked set point. After an adjustment is entered,
and no key is pressed for 3 seconds, the green set point will blink and lock, and the oven will begin
to heat or passively cool to match the adjusted set point. It will then run indefinitely at that set point
until adjusted again, or until a heating profile is launched. Or until the oven is turned off.
Current Set Point
Current Oven Temperature