Sharp ViewcamZ VL-Z100S-S, Operation Manual

Page: 17 / 96

Preparation
7
Charging the Battery
Pack
1
Attach the battery pack to the
camcorder, and make sure that the
Power switch is set to OFF.
2
Connect the supplied power cord to
the AC power socket on the AC
adapter, and insert the AC plug into a
power outlet.
3
Insert the DC plug into the DC IN
jack of the camcorder.
• The POWER/CHARGE (RED)
indicator lights up red.
• The POWER/CHARGE (RED)
indicator turns off when the battery is
charged.
4
Remove the DC plug from the DC IN
jack, then remove the AC adapter
from the power outlet.
• The chart specifies the approximate times in
minutes.
Notes:
• Charge the battery pack between 10°C and
30°C. The battery pack may not charge
properly at temperatures too low or too
high.
• The battery pack and AC adapter become
warm during charging. This is not a
malfunction.
• Using the zoom (see page 21) and other
functions or turning the power on and off
frequently will increase power consump-
tion. This may result in a decrease in the
actual recording time compared to the
maximum continuous recording time listed
above.
• The charging time and recording time may
vary depending on the ambient tempera-
ture and the condition of the battery pack.
• See pages 72 and 73 for more information on
using the battery pack.
• Charge only SHARP model BT-L227 battery
packs. Other types of battery packs may
burst, causing personal injury and damage.
• When attaching the supplied audio/video/S-
video cable, remove the DC plug, open the
terminal cover and connect it.
BT-L227
Charging
time
Battery
pack
Max.
continuous
recording time
Max.
continuous
playback time
on LCD
120
145 125
Charging time and maximum
continuous recording and playback
times in Tape modes
LCD
closed
LCD
open
125
AC power socket
To power
outlet
DC plug
DC IN jack
POWER/CHARGE (RED)
indicator
VL-Z300S/VL-Z100S-GB-005-019 04.2.12, 1:54 PM 7