Sharp SW-100H, Instruction Manual

Page: 42 / 83

Installing Material Stop Bracket
Step 1 - Install the depth bar (Fig 9, #2) and
tighten the set screw (Fig 9, #1). (The
depth bar is taken off from the
machine base during transit for safety
reason.
Step 2 - Lift the saw bow and clamp material
securely with vise.
Step 3 - Lower the saw bow to allow about 1
mm clearance between saw blade
teeth edge and the top of the
material. Then measure your desired
cutoff length.
Step 4 - Loosen the fastening bolt (Fig 9, #3)
Step 5 - Slide and position the stopper (Fig 9,
#6) so that the end of stopper faces
the direction of the front end of the
material. Then tighten the stopper
handle (Fig 9, #5) to fix the stopper in
the bracket (Fig 9, #4).
Step 6 - Move the stopper bracket (Fig 9, #4)
toward the workpiece so the stopper
end just touches the front of the
material, then tighten the fastening
bolt (Fig 9, #3).