Sharp SoftBank 203SH, User Manual

Page: 18 / 134

16
Desktop Holder
Use AC Charger (SHCEJ1) with Desktop Holder (SHEEV1;
optional accessory).
Insert Micro USB plug of AC Charger into connector port of
Desktop Holder
・Insert Micro USB plug in correct orientation; otherwise,
connector port of Desktop Holder may be damaged. Confirm
contours and orientation of Micro USB plug, then insert it
with tabs (○) facing down.
Plug AC Charger into AC outlet after rotating blades out as
shown
Place handset into Desktop Holder with Charging Terminals
facing down
Tilt back handset and secure it with lock lever
Notification Lamp illuminates while charging, and goes out
when charge is full.
Remove handset and then Micro USB plug from Desktop Holder,
then unplug AC Charger and retract blades
・To remove handset, tilt it toward you while holding Desktop
Holder.
USB Charging
Connect handset to a PC with Micro USB Cable (SHDDL1;
optional accessory).
・Power on handset and PC first.
・To use Fast transfer mode, install USB Cable driver on the
PC beforehand.
・Handset may not charge or charge slowly depending on PC
status/environment.
Open Port Cover
・Use notch to slightly lift Port Cover, then gently pull it
open being careful not to dislodge it.
Insert Micro USB plug of Micro USB Cable into External Device
Port
・Insert Micro USB plug in correct orientation; otherwise,
External Device Port may be damaged. Confirm contours and
orientation of Micro USB plug, then insert it with tabs (○)
facing down.
・Handset supports two types of Micro USB plug.
Insert Micro USB Cable into PC USB port
Notification Lamp illuminates while charging, and goes out
when charge is full.
Remove Micro USB Cable from handset and PC, then close Port
Cover