Sharp R-270, Operation Manual

Page: 309 / 312

GB-32
GB
TROUBLESHOOTING
If you think the oven is not working properly there are some simple checks you can carry out yourself
before calling an engineer. This will help prevent unnecessary service calls if the fault is something simple.
Follow this simple check below:
place half a cup of water on the turntable and close the door. Select HIGH and programme the oven to
cook for 1 minute.
I. Does the oven lamp come on when it is cooking?
2. Does the turntable rotate?
3. Does the cooling fan work? (Check by placing your hand above the air vent openings.)
4. After I minute does the audible signal sound?
5. Is the water in the cup hot?
If you answer "No" to any question first check that the oven is plugged in properly and the fuse has not
blown. If there is no fault with either; check against the chart below.
NOTE:
If you cook food for more than the standard time (see chart below) using the same cooking mode, the
oven's safety mechanisms automatically activate.The microwave power level will be reduced.
Cooking Mode Standard Time
Microwave HIGH cooking 20 Minutes
WARNING:
Never adjust, repair or modify the oven yourself. It is hazardous for anyone other than a
SHARP trained engineer to carry out servicing or repairs.
This is important as it may involve the removal of covers that provide protection against
microwave energy.
• The door seal stops microwave leakage during oven operation, but does not form an airtight seal. It is
normal to see drops of water, light or feel warm air around the oven door. Food with a high moisture
content will release steam and cause condensation inside the door which may drip from the oven.
• Repairs and Modifications: Do not attempt to operate the oven if it is not working properly.
• outer Cabinet & Lamp Access: Never remove the outer cabinet. This is very dangerous due to high
voltage parts inside which must never be touched, as this could be fatal.
Your oven is not fitted with a lamp access cover. If the lamp fails, do not attempt to replace the lamp
yourself, call a SHARp approved service facility.
QUERY ANSWER
Draught circulates aro-
und the door.
When the oven is working, air circulates within the cavity.
The door does not form an airtight seal so air may escape from the door.
Condensation forms in
the oven, and may drip
from the door.
The oven cavity will normally be colder than the food being cooked, and so
steam produced when cooking will condense on the colder surface.
The amount of steam produced depends on the water content of the food
being cooked. Some foods, such as potatoes have a high moisture content.
Condensation trapped in the door glass should clear after a few hours.
Flashing or arcing from
within the cavity when
cooking.
Arcing will occur when a metallic object comes into close proximity to the
oven cavity during cooking.This may possibly roughen the surface of the
cavity, but would not othetwise damage the oven.
Arcing potatoes. Ensure all "eyes" are removed and the potatoes have been pierced, place
directly onto the turntable or in a heat resistant flan dish or similar.
The display is lit but the
control panel will not
work when pressed.
Check the door is closed properly.
oven cooks too slowly. Ensure correct power level has been selected.
oven makes a noise. The microwave energy pulses oN and oFF during cooking/defrosting.
outer cabinet is hot. The cabinet may become warm to the touch - keep children away.
00_User manual - R270_9_languages.indb 32 2016-07-15 13:00:52