E-3
INSTALLATION INSTRUCTIONS
1. Rem ove all packing m aterials from the oven cavity . Check the unit for any dam age, such as a
m isaligned door, dam aged gaskets around the door or dents inside the oven cavity or on the door.
If there is any dam age, please do not operate the oven until it has been checked by a SERVICE CENTRE
APPROVED BY SHARP and repaired, if necessary.
2. Accessories provided
1) Turntable tray
2) Roller stay
3) Operation m anual and cooking guide
3. Locate the roller stay in the centre of the oven, then fit the turntable on the roller stay. M ake sure the
turntable and roller stay are centrally located and locked together. NEVER OPERATE THE OVEN
WITHOUT THE ROLLER STAY AND TURNTABLE.
4. The oven should not be installed in any area w here excessive heat and steam are generated, for
exam ple, next to a conventional oven unit. The oven should be installed so as not to block ventilation
openings.
Allow at least 15 cm on the top of the oven for free air space.
5. Neither the m anufacturer nor the distributors can accept any liability for dam age to the m achine or
personal injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage m ust be single phase 220V, 50Hz.
OVEN DIAGRAM
8. Door open button
9. Control panel (See page E-4)
10. Waveguide cover
11. Power supply cord
12. Turntable
13. Roller stay
1. Ventilation openings
2. Oven lamp
3. Door hinges
4. Door safety latches
5. See through door
6. Door seals and sealing surfaces
7. Coupling
13
12
10
1
9
8
7
6
5
4
4
3
2
11
http://www.usersmanualguide.com/
