Sharp MX-M350-N, Operation Manual, Page: 151 / 228

STORING, USING AND DELETING JOB PROGRAMS
5-43
5
Calling up a job program
1
Press the [#/P] key.
2
Touch the number key of the desired job
program.
The screen
automatically closes and
the job program is called
up. A number key that
does not have a job
program cannot be
selected.
3
Set the number of copies if needed and
then press the [START] key.
Copying will begin using
the settings of the job
program.
Deleting a stored job program
1 Press the [#/P] key.
2
Touch the [STORE/DELETE] key.
3
Select a storage register number of the
program to be deleted.
If a number key for which
no job program has been
stored is selected, the
screen will change to the
screen of step 4 on the
previous page for storing
a job program.
4 Touch the [DELETE] key.
The selected program is
deleted and you return
to the screen of step 3.
To return to the screen of
step 3 without deleting
the job program, touch
the [CANCEL] key. In
both cases, touch the
[EXIT] key displayed in the screen of step 3 to exit
the job program mode.
LOGOUT
JOB PROGRAMS
PRESS PROGRAM NUMBER.
RECALL
LOGOUT
M NUMBER.
RECALL STORE/DELETE
EXIT
STORE/DELETE
NOTE
If overwriting of programmed copy settings has been
prohibited in the administrator settings, it will not be
possible to store or delete a job program. (See page
17 of the administrator settings guide.)
RECALL STORE/DELETE
A JOB PROGRAM HAS BEEN ALREADY STORED
IN THIS LOCATION.
CANCEL DELETE STORE
Copy_SEC.book 43 ページ ２００６年１２月１３日 水曜日 午後３時１分