Sharp FO-DC635U, Service Manual

Page: 16 / 166

FO-DC635U
1 – 13
5) a: Attach the LIU board to the metal plate, positioning the modular
jacks as shown. The bottom edge of the board should fit into the
slots indicated by the arrows. Secure the LIU board with two of the
6 mm screws.
b: Attach the provided metal side plate.
6) Replace the metal plate and secure with screws in the order
shown.
7) Attach the dual line control board.
a: Insert the bushing into the hole in the dual line control board from
the outer side and secure it with the collar on the inner side.
b: Insert the winged end of the pin spacers into the metal plate, with
wings extended out vertically.
c: Attach the board so that the connector inserts into the connector
in the metal plate. Make sure that the pin spacers go into the holes
in the board. Secure the board with the 18 mm screw (which goes
into the bushing) and the remaining 6 mm screw. Tighten the
screws in the order shown.
8) Fasten the band to the core as shown and cut off the excess end.
Insert the cable through the core and wind it around the core twice.
9) Connect the cable to the LIU board and the dual line control board.
Secure the core band with the 10 mm screw.
10)Replace the rear cover.
(Be sure to replace the screw that secures the small cover in the
same position, as it is for plastic.)
11)Affix the “”LINE 2” label above the new jack.
a
b
1
2
3
4
b
a
c
1
2
For plastic
LINE 2