Sharp FO-DC635U, Service Manual

Page: 15 / 166

FO-DC635U
1 – 12
8. Replacing the Verification Stamp (FO-45VS)
If you are using the Verification Stamp function, you will need to
replace the ink cartridge in the stamp unit when it runs out of ink (when
the stamped mark on original documents becomes faint). A new ink
cartridge can be obtained from your dealer.
1) Remove the ADF exit tray.
2) Press down on the protruding tab of the green ink cartridge and pull
the cartridge out with your fingers.
3) Insert the new ink cartridge into the machine (make sure that the
tab is facing out).
4) Replace the ADF exit tray.
9. Installing the Dual Line Kit (FO-60DL)
Note: The FO-60DL Dual Line Kit cannot be installed if the FO-NP1
Network Printer Kit is installed.
Important! The following procedure is to be performed only by a qual-
ified service technician. Be sure to turn off the power, unplug the
power cord, and unplug the telephone line before proceeding. In addi-
tion, touch a grounded piece of metal to discharge any static electricity
that may be on your body. Make sure that an extension phone is not
connected to the machine.
1) Press the cover release to open the print compartment cover.
2) Remove 6 screws from the rear cover.
(Remember which screw secures the small cover on the left side of
the rear cover, as it must be replaced in the same position).
Remove the small cover, and then remove the screw underneath.
Remove the rear cover.
3) Remove 6 screws and then remove the metal plate.
4) Remove the screw that holds the small side plate to metal plate
that was removed Step 3. Slide the small side plate up and remove
it from the metal plate. (Note: The small side plate is not no longer
needed, however, the screw is used again in “b” of Step 5.)
1
3
2