Sharp FO-DC600, Service Manual, Page: 8 / 150

FO-DC600U
[8] Installing the Third Paper Cassette (FO-CS1)
Important! Be sure to turn off the power and unplug the power cord
before proceeding.
1
Remove the packing material and tape from the third paper cassette.
2
Remove the covers from the sides of the second cassette (the cas-
sette already installed on the machine), using a flat-head screwdriver
to pry each of the catches at the bottom of the covers free (2 on the
right cover, 3 on the left cover).
1 – 5
F
Replace the rear cover.
(Be sure to replace the screw that secures the small cover in the
same position, as it is for plastic.)
9
Connect the cable to the LIU board and the dual line control board.
Secure the core band with the 10 mm screw.
For plastic
G
Affix the “”LINE 2” label above the new jack.
LINE 2
3
Insert the green gear into the third cassette as shown. The side of
the gear that has the small thirdly gear should face the inside of the
cassette, and should fit onto the metal shaft. Push the gear in until
the tab on the outer side goes into the slot on the metal shaft. (Note:
The gear is only used in the third cassette.)
4
Place the machine on top of the third cassette, and remove the small
cover from the rear of the second cassette. Connect the 10-pin cable
as shown, and insert it behind the guide indicated by the white arrow.
5
Change the positions of the connectors on the circuit board of the
third cassette as shown (do not change the connectors on the sec-
ond cassette). Replace the small cover on the rear of the second
cassette, and attach the provided small cover on the rear of the third
cassette.
6
Attach the large support plate and then the small support plate to the
right side of the cassettes. Use 6 mm screws for the holes marked
with “A”, and 10 mm screws for the holes marked with “P”. Secure
the screws in the order indicated by the numbers.
A2 A2
A1 A1
P3 P3A3
A3
A3 A3
A4 A4
P4 P4
A4 A4
2
1
7
Attach the support plate to the left side of the cassette. Use 6 mm
screws for holes marked with “A”, and 10 mm screws for holes marked
with “P”, securing the screws in the order indicated by the numbers.
(Note that the top hole on the right does not require a screw.)
A1
A3
A4
A2
P6
P5