7
0800 862 0453
8
www.sharkclean.eu
b
c
Upper Cord
Storage Wrap
WARNING:
To reduce the risk of electric shock, unplug the unit before assembling, adding or removing
attachments or converting modes.
WARNING:
The On/Off switch is on the top of the
Lift-Away
®
canister. Always ensure the power is OFF
(“O” position) before plugging and unplugging.
TO ASSEMBLE:
1
Place the floor nozzle on a level surface.
2
Align the tube of the floor nozzle with the tube on the
Lift-Away
canister and lower until you hear the two
pieces click into place.
(Fig. 8)
When attaching the motorised floor brush, ensure
that the latching mechanism is fully locked in place
to ensure electrical connection has been made.
3
Attach the end of the extension wand to the tube on
the back of the
Lift-Away
canister until it clicks into
place.
(Fig. 9)
4
Slide the accessory holder (a) positioned opposite
the upper cord wrap, over the extension wand. Align
the tab with the groove and push down.
(Fig. 10)
5
Push the handle (b) onto the top of the extension
wand until you hear it click into place.
(Fig. 10)
6
Insert the end of the stretch hose (c) into the
connector on the back of the
Lift-Away
canister.
(Fig. 10)
7
Store the dusting brush (d) and the crevice tool (e)
on the mounts of the accessory holder.
(Fig. 10)
Fig. 8
Fig. 9
Fig. 10
a
d
e
Mode 1: Upright Vac
TO USE:
1
Rotate the cord release to quickly release the power
cord.
2
Secure the power cord in the cord hook.
= Brush Roll ON
= Bare Floor
= OFF
3
Press the On/Off switch
(a)
to the “I” position to
vacuum bare floors (straight suction only) or to the
“II” position to engage the motorised floor brush (for
vacuuming carpets and rugs).
(Fig. 11)
IMPORTANT:
The motorised brush indicator light
(b)
will illuminate green when motorised floor brush
is on, or red if there is a blockage or jam.
(Fig. 11)
This feature is designed to protect your Lifetime
Belt that powers your motorised floor brush. See
Checking for Blockages.
4
Gently press the floor nozzle down with your foot
while you grasp the handle and tilt it back towards
you.
(Fig. 12)
NOTE:
The rotating brush on the motorised floor
brush will not spin unless the nozzle is flat against
the floor and the handle is tilted back.
5
Due to the huge suction power of this vacuum,
it may become necessary at times to adjust the
suction release (c) on the handle. (Fig. 11) If the
vacuum seems difficult to push or pull or if it is
lifting up area rugs, adjust the suction release
by rotating the collar 90° counterclockwise to
open the valve. Rotate the collar clockwise to
close the valve when you need high suction and
for vacuuming floors.
6
Empty dust cup after vacuuming and periodically
during use when it appears full. (See “Maintenance”
section for instructions.)
7
When you are finished vacuuming, turn the
vacuum off.
Fig. 12
Fig. 11
b
Suction
Release Collar
a
Release suction
for easier push &
pull on high pile
carpets and
area rugs.
c
Summary of Contents for NV350UKC
Page 1: ...NV350UKC Owner s guide ...
