15
0800 862 0453
16
www.sharkclean.eu
CLEANING THE MOTORISED FLOOR BRUSH
When your motorised floor brush needs cleaning or locks
onto an object, it automatically shuts down to prevent
damage to your lifetime belt. The indicator light will
illuminate red warning you to turn off the vacuum and
clear blockage immediately. The light will reset itself
once blockage has been cleared and power has been
cycled on/off or vacuum has been locked in the upright
position.
1
Detach the motorised floor brush from the portable
Lift-Away
®
canister.
2
Inspect the opening underneath and the rotating
brush. If a build-up of debris is present, remove it.
Carefully cut anything wound around the rotating
brush with scissors. Avoid damaging or cutting the
bristles.
(Fig. 28)
CHECKING FOR BLOCKAGES
Blockages may cause your vacuum to overheat and shut
down. To prevent this from happening, check potential
blockage areas after heavy use or if you detect a loss of
suction or poor cleaning performance.
1
Dust Cup
Dust cup may be full. Empty dust cup.
2
Pre-Motor & Post-Motor Filters
• Pre-motor filters require washing every 3 months
for optimum performance.
The post-motor HEPA filter needs to be washed
every 2 years.
• Ensure that all the filters are clean.
3
Accessories
• Check intake openings:
- Extension Wand
- Dusting Brush
- Crevice Tool
- Turbo Brush
Make sure you are working in a well
lit area and use a flashlight to help
search for blockages.
Maintenance - cont’d
4
Hose and Connections to Vacuum
• Detach the stretch hose from the back of the
portable
Lift-Away
®
canister by squeezing the tabs
together and pulling up.
(Fig. 29)
Straighten out
the hose and look inside for blockages.
• Remove the dust cup and extension wand and
separate the portable
Lift-Away
canister from the
motorised floor brush. Look in all 4 openings for
any blockages.
(Fig. 30)
5
Motorised Floor Brush
• Detach the hose on the motorised floor brush
at the top by squeezing the tabs together and
pulling out, and at the bottom by pulling out the
connector. Inspect inside the 3 holes.
(Fig. 31)
Fig. 29
Fig. 30
CAUTION:
Turn power off and unplug from outlet
before servicing.
CAUTION:
Turn power off and unplug from outlet
before servicing.
Fig. 31
Rotating
Brush
Fig. 28
Summary of Contents for NV350UKC
Page 1: ...NV350UKC Owner s guide ...
