sewerin FerroTec FT 10, Operating Instructions Manual

Page: 10 / 36

4
3 Product description
3 Product description
3.1 Setup
For overviews including all part names for the
FerroTec FT 10
,
see the front cover flap ( Fig. 1).
3.2 Power supply
The product is powered by special inbuilt NiMH rechargeable
batteries. Only SEWERIN service personnel or other authorised
specialists may replace the rechargeable batteries.
For information on charging the batteries see section 6.1 on
page 21.
3.3 Operating mode
The operating mode determines how the sensor area operates.
Note:
The selected operating mode only affects the switching on and
off of the beep.
You can choose between two operating modes.
●
Hold mode
Place your thumb on the sensor area to listen. When you re-
move your thumb from the sensor area, the beep goes off.
● Toggle mode
To listen, briefly press the sensor area with your thumb. If you
briefly touch the sensor area with your thumb again, the beep
will switch off.
The operating mode is set in the menu under MODE . Informa-
tion about changing the setting can be found in section 5.5.2 on
page 19.
Information about how to enable the audible signals in both oper-
ating modes can be found in section 5.4 on page 18.