12 of 22
the fitting stable, wrench another one to tighten in 1.25 turns to prove it’s not blow-by after
installing the front ferrule, back ferrule and nut.
Figure 2-6 Compression Fitting Connector Installation
Attention
:
When installing the fitting, you should manually use spanner to wrench it tighten by 1/2 turn pulling up,
(imported Compression Fitting should use spanner to be tighten in 1,25 turns) to prove its not blow-by
after your installing the front ferrule
、
back ferrule and nut. Please note you should use two spanners to
operating, one spanner for locking the fitting stable and another one for revolving the nut. Especially when
you dismantle the tube, you should operate by the two spanners otherwise fitting will become flexible
which will affect its airproof function.
2.4 Electrical Installation
2.4.1 General
With simple switching power supply, PC100-D PC is available for +15to +24 VDC
(single-ending). Customer can choose as need.
Customer can choose 9 pin male Sub-D. 9 pin male Sub-D connector is the SEMI
Standard compatible, both 0-5V analog signal control and output and communicate with
PC via RS485 available.
Gland
Nut
Back ferrule
Front ferrule
Fitting
