detect compressor safeties like high pressure when the compressor is
running.
Compressor 2 - 4 contacts will only be available if system has been
configured for more than one compressor.
Selecting Reset All will reset all contacts back to the Off position.
6.3. Network
6.3.1.Ping
The ping feature is used to test the IP network.
To use ping, set the ping address and then select start. The first result line
shows the IP addresses you are pinging from (units IP address) and the
second line will show 4 time values in milliseconds.
Ping will send 4 messages to specified address and measure in
milliseconds how long it will take to get a reply. If no reply within 5
seconds the result will show Fail for that particular ping request.
6.3.2.Console
The console is currently only used to monitor serial port messages. Select
the serial port to monitor by using the arrows keys. Select 1 to start
monitoring. To stop/pause messages, you can press key 2 anytime. Press
Enter to clear the screen. Select back top stop console or to go back and
select another serial port.
6.4. Clear Alarm Log
Selecting Clear Alarm Log will display a confirmation screen where you
have to confirm that you want to clear the alarm log. Pressing 2 or the
Back button will cancel this request.
6.5. Clear All Logs
Even though you only can look at the alarm log from the control panel,
there are several other logs used as well. These logs can be read using
WebSentry if the unit is connected to Internet.
Use Clear All Logs to clear all the logs and not just the alarm log.
6.6. Commission
When control board initially is configured loaded with the latest control
software, unit is prepared to make it safe and easy to use when testing unit
before delivery to customer. When test completed, the Tested option is
changed to Yes and can never be changed back again.
OperatorPanel_4.15.14.doc
Page 26
7/12/2012
