PendingPurge means that we are waiting for the compressor(s) to stop
before we can start purging. The compressors have been notified that they
need to stop
Note that you only can start purge if Purge has been enabled under Factory
Settings.
3.3. System Restart
When selecting System Restart you will see a confirmation screen where
you have to confirm that you want to restart the system. Pressing 2 or the
Back button will cancel this request.
3.4. Alarm Log
This is the alarm log. It lists all alarms since the alarm log last was cleared
(from the Service menu). Last alarm at the top. The top line shows the date
for select alarm. You select an alarm by using the Up and Down arrows.
Selected alarm is indicated by an arrow in the left margin. The alarm log
will scroll one alarm at a time rather than a page at a time.
3.5. System Status
The status screen shows the status for different internal system
components. It’s main purpose is for troubleshooting a running system
where the information here can be passed back to tech support.
The status feature has been grouped into 4 areas. Environment shows
status for the environment control (Air Temp, Humidity and Pool Heat)
including air heater, pool heater and heat recovery.
The compressor area shows the status for all compressors in the system.
Each compressor uses two lines. The first line is the operational status.
The second line (starting with ->) lists the status of the compressor valves
and contactor as a two letter code. The codes are in the following order:
CC
Compressor Contactor
PD
Pump Down Valve
RH
Reheat Valve
AC
A/C Valve
PH
Pool Heating Valve
The ventilation area shows the status of the different ventilation related
components including the OACC.
The network area shows the status for network related components.
The serial ports area show serial port status.
OperatorPanel_4.15.14.doc
Page 13
7/12/2012
