INSTALLATION OF THE CR/53 CONTROL UNIT
Position the appliance in proximity of the parking space saver in a way to reduce the length of the connection cable,
to the rest of the system, to a minimum.
For greater protection from atmospheric agents it is recommended to position the control unit under a roof or, even
better, in a room that has two lateral walls. It is also good practice to install the appliance higher than 1.5 m where
possible in order to prevent it being tampered with by children.
WHERE TO POSITION THE CONTROL UNIT
The control unit leaves the factory with the lid positioned to open from the left side.
If you wish to open the lid from the opposite side, proceed as follows:
ATTENTION: This operation must be carried out
before fixing the container to the wall.
Insert a flat tip screwdriver into the fixing recess of the hinges
positioned on the rear of the base and lever on the attachment
notch of the hinge itself, pulling the cover at the same time.
(see Fig.1)
Fig.1
Insert a flat tip screwdriver into the fixing recess of the hinge
positioned on the front part of the cover and lever on the
notched attachment of the hinge itself, pulling the hinge at the
same time. (see Fig.2)
Fig.2
Re-mount the hinges on the right side of the base by
inserting them in the relevant seats with the attachment
notch facing towards the inside of the container until the
attachment clicks (see Fig.3).
Fig.3
LID SET-UP FOR LID OPENING TO THE RIGHT
!
D
AL
1
96
5
Pag. 3/7
K
IT
/4
5
I E
