SEPTENTRIO PolaRx5S, User Manual

Page: 26 / 107

4.2. CONF I GUR I NG THE POLARX5S NTR I P CASTER
Step 3: Is the NTRIP Caster working?
I n the ‘ Status ’ tab of the NTR I P Caster window, you can see a summary of the NTR I P Caster
to make sure that it has been properly con fi gured. I n the example shown in Figure 4-11, two
rover clients are connected to the mount point named ‘ Leuven ’ as user ‘ Mildred ’ .
I f the client rover receivers are con fi gured to send a GGA message to the caster (as was the
case in Figure 4-12), then their position will also be visible.
Figure 4-11: Connecting as a client to the PolaRx5S NTR I P Caster
On the NTRIP Client side
Rover receivers can connect to the NTR I P Caster by entering its I P address and Port as shown
in Figure 4-12. After clicking ‘ Ok ’ , the mount point source table will be fi lled and a mount
point can be selected. The user name and password can then be entered and within a few
seconds, the rover receiver should report an RTK
fi xed position.
Figure 4-12: Connecting as a client to the PolaRx5S NTR I P Caster
26