SEPTENTRIO PolaRx5S, User Manual

Page: 18 / 107

3.3. CONNECT I NG TO THE POLARX5S V I A THE WEB I NTERFACE
3.3.3 Using the Ethernet cable
Connect the Ethernet cable (CBLe_ETH_MS) to the socket labelled ETH on the front panel of
the PolaRx5S as shown in Figure 3-9.
Figure 3-9: Connecting to the front-panel Ethernet socket
For the most straightforward setup, the RJ45 socket of the Ethernet cable should be
connected to a network running a DHCP server. The
I P address assigned to the receiver
will be associated with the hostname ‘ PolaRx5S- xxxxxxx ’ , where xxxxxxx are the 7 digits of
the serial number of the GNSS Receiver Board (GRB) inside the PolaRx5S. This number can
also be found on an identi
fi cation sticker on the receiver housing. You can then make a
connection to the receiver using the web address http://PolaRx5S- xxxxxxx .
Figure 3-10 shows a screenshot of an Ethernet connection to a PolaRx5 receiver with serial
number 3013369 using
‘ http://polarx5-3013369/ ’ .
Figure 3-10: Connecting to the Web I nterface over Ethernet
18