CHAPTER 4. CONFIGURING THE ALTUS NR3 AS A ROVER
4.2.5 Connecting via WiFi
The setup described in this section is represented schematically in Figure 4-11.
Figure 4-11:
Base-Rover con
fi
guration using WiFi
Step 1: Check the receiver is in Rover mode
Section 4.1 shows how you can check that the Altus NR3 is set to work as a rover.
Step 2: Configure rover input of differential corrections
Configure the rover WiFi connection as Client over USB
If the base station receiver has been con
fi
gured as a WiFi Access Point then the rover
should be con
fi
gured as a client. In client mode however, the rover can make only one WiFi
connection which in this case, will be with the base station. For this reason, the rover should
be con
fi
gured using the USB connection.
The steps below describe how to connect via USB to the Altus NR3 and con
fi
gure it in WiFi
client mode.
•
Plug the USB cable of the rover unit and connect to the web interface using
192.168.3.1
•
On the
‘
Communication/WiFi
’
tab, select
‘
Client
’
in the Mode parameter as shown in
Figure 4-12.
35
Summary of Contents for ALTUS NR3
Page 1: ...Altus NR3 User Manual ...
