Installation
2–14
700-0058 R001
2.9. Step 8: Installing the Driver’s Indicator Panel
If you wish to install the driver’s indicator panel at a later time, please proceed to
“2.12. CAN Network” on page 2–16.
The EX4 Plus 35 DVR with the Smart-Link module has an interface for a driver’s
indicator panel. The basic version of the panel consists of a heavy duty, vandal-
resistant switch with an integrated green indicator ring around the switch button.
See Figure 2-11. The indicator panel has a weather-sealing gasket attached to
prevent water penetration behind the device.
The indicator panel is supplied with a 12" cable and connector. A 10-foot
extension cable is provided as a standard accessory with the driver’s indicator
panel. Extension cables of different lengths can be ordered from Seon Design.
Please contact your sales representative to order a different length cable.
To install the indicator panel:
1. Drill a ¾" hole in the desired location. Ensure that the area behind the hole is
clear of obstructions before drilling.
2. Remove the mounting nut from the indicator panel.
3. If you have purchased the video recording label, install the label between the
button and the dashboard.
4. Feed the connector and cable through the mounting hole.
5. Reattach the nut.
2.9.1 Status of the Driver’s Indicator Panel
Pushing the alarm button of the driver’s indicator panel causes an alarm event to
be recorded by the DVR. The button corresponds to Alarm 1 on the Smart-Link
alarm harness. The indicator ring indicates the status of the DVR. See Table 2-4.
Figure 2-11
Driver’s indicator panel
Indicator ring lamp
Alarm button
Table 2-4
Driver’s indicator panel status
Ring Color
Function
No green light
No power to the DVR, or ignition is not on.
Flashing green
The DVR is powered up, but not recording.
Solid green
The DVR is powered up and recording.
