Sentryway CurveTrack, System Installation Manual, Page: 60 / 70

VIDEOSURVEILLANCE SYSTEMS
SENTRY
WAY
®
CT V2 001
Page 60 of 70
System Installation Guide
9. Installation of RF adapter and terminator boards
9.1 RF Adapter PCB Installation (See Figure 9-1)
9.2 Terminator board installation
9.1.1
9.1.2
9.1.3
9.2.1
9.2.2
Align the top, unthreaded hole on each extension bar with the corresponding hole in the
conductor end plug and install a screw with captive washer in each. Do not tighten either screw
yet.
Face the component side of the RF Adapter PCB down the system run. Align the two corner holes
on the top edge of the PCB with the standoffs on the bumper stop bracket. Install and tighten two
screws with captive washers.
Rotate the extension bars slightly to align the threaded bottom hole on each bar with the
corresponding center slots in the top edge of the PCB and install, but do not tighten, a screw with
captive washer in each slot. Next, tighten the screws in the conductor end plugs. Then, lift the two
conductors as far upward as possible and tighten the screws in the PCB slots
At the opposite end of the system run, position the Terminator PCB against the conductor end
plugs with the PCB components facing away from the system run.
Install and tighten two screws with captive washers to secure the PCB.