Sentryway CurveTrack, System Installation Manual

Page: 27 / 70

VIDEOSURVEILLANCE SYSTEMS
SENTRY
WAY
®
CT V2 001
Page 27 of 70
System Installation Guide
4.5 Fastening Support Hardware to Steel Beams - Parallel
When the installation requires the system run to be parallel to the steel beams, channel is used as a spine to
bridge the beams at the mounting point for each rail section as shown in Figure 4-4. Lengths of channel should
be cut 0.3 meter longer than the outside distance between the beams to allow for mounting hardware.
Position each channel (1, Fig. 4-4) with open side down. Place U – bolts (2, Fig. 4-4) around
channel, facing up, and through beam clamps (3, Fig. 4-4) and M10 spring lock washers (4, Fig.
4-4). Thread M10 x 1.5 hex nuts (5, Fig. 4-4) loosely to each end. These assemblies can be made
in the quantity needed for each system run before attaching to bottom of beams.
Raise and center channel assemblies in the desired locations on the beams, and slide lamps and
U–bolts firmly against the inside legs of the beams. Check to ensure that the distance between
channels coincides with the desired location of threaded rod hangers.Verify approximate
“squareness” of channels to the beams, and then tighten hex nuts securely.
4.5.1
4.5.2