Sentryway CurveTrack, System Installation Manual, Page: 58 / 70

VIDEOSURVEILLANCE SYSTEMS
SENTRY
WAY
®
CT V2 001
Page 58 of 70
System Installation Guide
7.3.1
7.3.2
Raise the first two conductors up to the first rail section and snap them into the plastic track. The
conductors should be positioned with the end plugs protruding approximately 12mm from the
beginning of the plastic track in the first rail section.
Proceed down the length of the system run soldering connector pieces between conductor
lengths, smoothing joints, and pressing conductors into the track.
NOTE
7.3 Inserting Conductors into Plastic Track
The copper conductors should be pressed into the plastic track
sections only after the solder joints have been allowed to cool and the
joints have been inspected and smoothed as necessary.
7.3.3
7.3.4
7.3.5
Allow 0.5 in. (12mm) of clearance between the end of the conductors and the end of the final
track section on the Terminator board end of the system run. Hold the two conductor ends
together and, using a hacksaw, remove the excess copper squarely.
De-burr the conductor end surfaces.
Solder both end plugs in place.