37
L
IS
H
E
N
G
System Commissioning - Programming Remotes
System Commissioning - Programming Remotes
Programming Remote Controls into the system
The DCC02 is supplied with two four code-hopping remote controls which are
intended for use with this product. The user can purchase additional remote controls
and add them to the system up to a maximum of 16 remote controls into the
memory of the built-in receiver at any given time.
The system is shipped from the factory in a blank state, i.e. there are no remote
controls learnt into the system.
When learning remote controls, always operate the remote control at
least 5 metres away from the wall console.
Ensure that no other remote controls are operating in the near vicinity
during this procedure as these remotes will be inadvertently learnt into
the system.
Learning a new remote into the system
The DCC02 stores remote controls in what is called “slots”. Each remote control
added to the system occupies a slot. A slot can generally only be overwritten or all
slots mass erased. The most common mistake is to not select an unallocated slot
when adding remotes to the system, which leads to the previous remotes learnt,
being overwritten. The following explains how to program the remotes correctly into
the system.
1
Press and release “LRN”
Press and release “LRN”
2
e
Single Beep
Single Beep
