Sentek RT6, Hardware Manual

Page: 51 / 90

CHAPTER 7: MOVING & STORING
Page 47
Chapter 7: Moving & Storing

Caution:

Caution:
The Sentek RT6 System has been designed as a
system that can be removed, transported, stored and
re-installed with care. It has not been designed as a
truly portable unit and therefore great care must be
taken when this is undertaken.
The SLA battery must be removed from the logger
housing whenever it is being moved or transported.
Failure to do this may result in mechanical damage.
To maintain your Sentek Warranty, system removal
and re-installation should only be undertaken by a
Sentek Authorized Installer
System Removal

Note: Some of these steps do not apply to EasyAG probes.
Removing those tubes is described in the EasyAG
Installation Manual.
The following steps are to be followed when
removing the system. This will ensure the system will
function correctly when re-installed:
Disconnect the Logger

Open the logger housing and disconnect logger
by carefully pulling out the connector
Remove SLA battery

Remove the front panel to gain access to the
battery

Remove the battery and replace the front panel
Disconnect the Probe/s

Unscrew the top cap

Unplug the 5-wire cable from the 5-wire board
Remove the Probe/s from the access tubes and
immediately place in transport tube/s

Grasp the probe handle and while holding the 5-