Sentek RT6, Hardware Manual

Page: 34 / 90

SENTEK
Page 30
2-pin plug at the other. The cables should be
connected to the "BATT" connector X6 and the
battery with the following color allocation (see
Appendix E – Overlay Diagram);
Battery Cable Red
= +
Black = -
EnviroSCAN Probe Cabling
– at probe

Note: This section is for EnviroSCAN probe cabling. The
EasyAG Installation Manual describes cabling
method for EasyAG probes.
Only the specified cable should be used to
interconnect probes with the logging facility.
The following is the method of connection of the
cable run to the probe;
1.
Loop the cable loosely twice through the ferrite
bead
(it will be repositioned later).
2. Pass the cable through the cable gland and into
the centre of the top cap assembly.
3. Strip back the outer sheath of the cable so that
150mm of inner cables are exposed.
4. Strip the inner cables to expose 5 mm of bare
copper conductor.
5. Screw the conductors into the 5-way connector
plug found on the 5-wire board according to the
wiring diagram in Appendix F. Check that the
connector is crimping the copper wire strands