Sentek RT6, Hardware Manual

Page: 39 / 90

CHAPTER 4: SYSTEM INSTALLATION
Page 35
Assembly
EnviroSCAN Probes

Note: This section does not apply to EasyAG probes.
A step by step assembly training guide is available in
EnviroSCAN probe assembly.ppt on the Distributor
Resource Kit CD.
With a permanent marker pen, write the probe
number on each probe (on the probe handle, top cap
and access tube) as per the system specification to
avoid mixing up the components during assembly and
for easy recognition in the field
Handle
Attach the probe handle to the probe rod with the use
of the backing plate and locating screws.
Interface board Attach the 5-wire board to the probe rod making sure
the connector pins are properly located in the socket
on the probe rod and secure using the screws.
A cable tie placed around the probe rod at the 5-wire
board connector that plugs onto the probe will
prevent it from becoming loose and causing
intermittent contact.
Fitting sensors
Slide sensors onto the probe rod while pressing on the
locator lever (highlighted on the picture) between the