SenTech STC-MBS322U3V, Product Specifications

Page: 60 / 65

No.15S103-01
60/65
STC-MBS510U3V / STC-MCS510U3V / STC-MBS322U3V / STC-MCS322U3V
Specifications and Use
’s guide
MultiROIsInMultiPayloads MultiROIs In MultiPayloads.
MultiROIRegistersValid Returns if the current ROI register set is valid and consistent.
Name Description
AcquisitionMode
Sets the acquisition mode of the device. It defines mainly the number of frames to capture
during an acquisition and the way the acquisition stops.
AcquisitionStart
Starts the Acquisition of the device. The number of frames captured is specified by
AcquisitionMode.
AcquisitionStop
Stops the Acquisition of the device at the end of the current Frame. It is mainly used when
AcquisitionMode is Continuous but can be used in any acquisition mode.
AcquisitionArm
Arms the device before an AcquisitionStart command. This optional command validates all the
current features for consistency and prepares the device for a fast start of the Acquisition.
AcquisitionFrameRate Controls the acquisition rate (in Hertz) at which the frames are captured.
TriggerSelector Selects the type of trigger to configure.
TriggerMode Controls if the selected trigger is active.
TriggerSoftware Generates an internal trigger. TriggerSource must be set to Software.
TriggerSource
Specifies the internal signal or physical input Line to use as the trigger source. The selected
trigger must have its TriggerMode set to On.
TriggerDelay Specifies the delay in microseconds (us) to apply after the trigger reception before activating it.
ExposureMode Sets the operation mode of the Exposure (or shutter).
ExposureTimeSelector
Selects which exposure time is controlled by the ExposureTime feature. This allows for
independent control over the exposure components.
ExposureTime
Sets the Exposure time when ExposureMode is Timed and ExposureAuto is Off. This controls
the duration where the photosensitive cells are exposed to light.
ExposureTimeAbs
Sets the Exposure time when ExposureMode is Timed and ExposureAuto is Off. This controls
the duration where the photosensitive cells are exposed to light.
ExposureTimeRaw
Sets the Exposure time when ExposureMode is Timed and ExposureAuto is Off. This controls
the duration where the photosensitive cells are exposed to light.
ExposureAuto
Sets the automatic exposure mode when ExposureMode is Timed. The exact algorithm used to
implement this control is device-specific.
ExposureAutoLimitMax Determine the upper limit of exposure time when ExposureAuto is set to Continuous.
ExposureAutoLimitMin Determine the lower limit of exposure time when ExposureAuto is set to Continuous.
Name Description
PayloadSize
Provides the number of bytes transferred for each image or chunk on the stream channel. This
includes any end-of-line, end-of-frame statistics or other stamp data. This is the total size of
data payload for a data block.
Name Description
LineSelector Selects the physical line (or pin) of the external device connector to configure.
LineMode Controls if the physical Line is used to Input or Output a signal.
LineInverter Controls the inversion of the signal of the selected input or output Line.
LineStatus Returns the current status of the selected input or output Line.
LineSource
Selects which internal acquisition or I/O source signal to output on the selected Line. LineMode
must be Output.
UserOutputSelector Selects which bit of the User Output register will be set by UserOutputValue.