Senstar LM100 calibration
Senstar LM100 Product Guide
Page 57
Recording the Sensitivity Profile
The recommended method for creating the Sensitivity Profile is to drag a screwdriver or similar
instrument along the fence fabric at a consistent height below, the luminaires. Beginning at the
luminaire AP (or the designated first luminaire according to the Head Sequence table) place the
screwdriver against the fence fabric and apply consistent pressure as you walk along the side of
the fence. Keep the pressure steady and maintain a uniform pace as you drag the screwdriver
along the fence fabric. When you reach the first fence post, lift the screwdriver over the post.
Continue dragging the screwdriver along the fence fabric maintaining a consistent distance below
the luminaires and lifting the screwdriver over each fence post until you reach the end of the
protected fence. Keep the pressure of the screwdriver and your walking pace as consistent as
possible. Repeat this process from the end of the protected fence back to the start point.
1.
Establish a connection between the UCM and the gateway.
2.
On the Config tab, select the Profile button.
3.
Verify that the All radio button is selected, and then select the Record button to begin
recording the Sensitivity Profile.
4.
At the luminaire AP, begin dragging the screwdriver along the fence fabric. Lift the screwdriver
over the post at each fence post (i.e., do not strike the fence posts with the screwdriver).
Note
If a sensitivity profile indicates a drop of 50 units within a 10 m length of
the fence, it indicates that there is likely a problem at that location either
with a luminaire or with the fence condition at that location (e.g., loose,
sagging, stretched).
Tip
Senstar recommends that you save a UCM file that includes the
recorded sensitivity profile. This can be useful for future maintenance
and troubleshooting activities.
Figure 52: Sensitivity Profile
raw sensitivity profile data
(gray line)
use the controls in the Profile field
select the Record button to start
recording the profile
(becomes Stop button while recording)
to setup the profile being recorded
