ENGLISH
Pag. 50
DEC HEX DEC HEX DEC HEX DEC HEX DEC HEX DEC HEX DEC
HEX
37
25
74
4A
111 6F
148 94
185 B9
222 DE
2.13
Detector identification on the control panel diplay
Every detector connected to the control panel (directly or on STG/IN8S module) is identified
by a code used for its configuration and contains all the principle data required to physically
identify it.
For example:
Figure 15) Detector number identification
2.14
Programming by PC
The MU+/S1-32 control panel is fully programmable by a personal computer with
a dedicated configuration software. The software has been designed to make the control
panel programming simpler and faster.
The control panel can be connected to a Personal Computer using the RS232C serial port
available on the main board. The correct serial connecting cable is necessary to connect the
control panel to the computer. The connector pin layout is shown below.
Figure 16) PC connection cable
2.15
TCP/IP optional module
Via an optional interface, to be connected to the RS232 port, it is possible to connect the
panel on a LAN/WAN network with TCP/IP protocol. By this type of connection, the following
features are possible:
CHN 02001
Module IN8 or detector address
from 0 to 255
Detector position from 01 to 08 if IN8
module is used or 00 if the detector
is connected on bus
1
Bus number (1-4)
Summary of Contents for MULTISCAN++/S1-32
Page 75: ......
