Maintenance and repair of the
swinglet CAM
Note:
You may need to install a driver the first time you upgrade your
firmware. The driver will be installed automatically but may cause the
firmware update to fail. If this is the case, retry the update process by
clicking ‘Update’ again, without disconnecting the battery or cable
from the drone or closing the ‘Updater
swinglet CAM
’ program.
5. Disconnect the USB cable and the battery.
It is important that both the drone and
eMotion
have the same software version
for them to work properly together. Make sure that you keep both up-to-date.
To check which version of
eMotion
you have installed, use the ‘About eMotion...’
item in the ‘Window’ menu. The
swinglet CAM
firmware version can be seen in
the Flight Parameters tab once connected (see section ‘Flight Parameters tab’ on
page 102).
7.2
Cleaning and storage
Use a damp cloth to wipe off dirt from the
swinglet CAM
. In order to avoid struc-
tural deformation of the wing, it is recommended to store the drone either in its
transport case or on a flat surface at room temperature.
Caution:
Never bring the
swinglet CAM
into direct contact with wa-
ter, as this may damage the electronics within the drone airframe.
7.3
Full airframe and sensor inspection
Beyond the general airframe inspection that is performed before every flight, we
recommend that you perform a full airframe and sensor inspection regularly to
keep your drone in good operating condition.
119
Summary of Contents for swinglet
