Operation
57
tery first. If the status LED flashes red, the charge level is too low. You
have to charge the rechargeable battery first (see „Charging the re
chargeable battery“).
After four seconds, the status LED starts flashing green. The flashing
indicates that a wireless connection is being established.
The status LEDs remain green once the transmitter and receiver are
connected. If the status LEDs do not remain green, either the charge
level is below 15% (see „Checking the charge level during use“) or the
transmitter and receiver are not paired (see „Pairing“).
Switching off the transmitter and receiver
►
▷
Press the button on the transmitter and the button on the receiver until
the status LEDs switch off.
Adjusting the input level on the camera
Once you have connected the receiver to the camera and switched it on,
you have to adjust the input level on the camera.
►
▷
If the camera has automatic gain control (AGC), you should disable this
function.
▷
Set the input level in the camera’s menu so that the audio signal does
not overload the input.
▷
During recording, regularly check the input level on the camera to make
sure that the audio signal is not overloading.
