DRM 85-C, DRM 85
09/2007
17/41
3.4.7 AF PCB and capsule removal
Figure 7: Chassis and AF PCB
The AF PCB [fig. 7, 007] is located inside the battery chassis [005] and is largely
hidden from view as it is behind the battery compartment; with the end cap
removed the end of the AF PCB (shown by arrow in fig. 8) can be seen.
Figure 8: Location of AF PCB
To remove the AF PCB, the flat ribbon cable [fig. 10, 012], has disconnected from
the AF PCB. This is done by lifting the black locking-latch on the connector
(fig. 9), and then the flat ribbon cable can be carefully pulled out from the
connector. Once the cable is free the screw [fig. 7,013] T06 Torx is unscrewed. Now
remove the screw holding the capsule in place [fig. 7], if it was not removed
earlier in section „capsule removal only“.
end of
AF PCB