User Manual
Z-SG2 / Z-SG2-L
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION MAY
BE REPRODUCED WITHOUT PRIOR PERMISSION.
www.seneca.it
Doc: MI-005370-EN
Rev. 1.0.0.2
Page 29
For example, if the tare ADC value is 5670 points and if the tare tracking ADC value is 10 points, a new tare
will be acquired if the ADC value of 5675 points is stable for 5 seconds.
FLOATING POINT REPRESENTATION OF THE MEASUREMENTS
It allows to configure the type of representation of the floating point values of the measurements (while the
configuration parameters do not change operation).
10.2.25.1.
FIRST PART H THEN L
The floating point value is represented so that the most significant part is on the lowest modbus address
(standard).
10.2.25.2.
FIRST PART l THEN h
The floating point value is represented so that the most significant part is on the highest modbus address.
DEVICE TEST
When the configuration is sent, by pressing the
button it is possible to check the
configuration sent:
