39
4.5 I/O Port Connection
This section describes how to make a required connection with the digital output, digital input
and ADC input port of Rhio10 for the users’ devices. The length of cables used for I/O port
connection should be less than 3 meters to ensure normal operation.
4.5.1 Digital Output Port
All digital output ports are equipped with a status LED, which illuminates when a relay point is
set to ON. An electric load can be connected as shown below by using OUTA1 and OUTB1 as
driving switches.
Figure 4-6 Connection of Digital Output Port
4.5.2 Digital Input Port
A digital input system operates regardless of the
±
polarity of the voltage and is insulated from
the internal circuits in the system. It can be configured as shown in Figure 4-7 and has a status
LED for each input, which illuminates when input voltage is issued.
Note)
Whilst it may operate in a voltage other than that specified (ON >
±
3.2V / OFF <
±
1.3V), be
sure to use the specified voltage to ensure the stable operation.
Load
