5 INSTRUCTIONS WITHOUT HANDSET
Display in Automatic and Manual Mode
5.1 Automatic Mode “AUTO”
• When the Door Controller is working in automatic mode the "AUTO" red led is on,
whereas the other two red leds are off.
• When the Door Controller is switched on, or after a self-resetting, it starts directly in
the automatic mode.
• All the signals sent by the main lift controller and by the external devices (barriers,
photocells, etc.) are active in this mode.
• Keys 2 and 3 are not functional during automatic mode.
• Key 1 selects Self Learning Cycle.
• When Key 4 is kept pressed for a while, the Door Controller (ca. 3 sec.), swit-
ches to the manual mode “MAN”.
5.2 Manual Mode “MAN”
• When the Door Controller is working in manual mode the "MAN" red led is on, whe-
reas the other two red leds are off.
• All signals coming from the main lift controller and from the external devices are igno-
red.
• The IM contact is deactivated, therefore the Door Controller does not recognize any
signal coming from the external devices to reverse door movement, such as photo-
cells or barriers.
• Opening and Closing commands may be manually input by pushing Key 2 (open) or
Key 3 (close).
• Key 1 selects Self Learning Cycle.
• When the key 4 is kept pressed for a while (ca. 3 sec.), the Door Controller switches
to the automatic mode “AUTO”.
• If no keys are pressed for at least 10 minutes, the Door Controller will switch to the
"automatic mode “AUTO”.
Both in automatic and manual mode the Door Controller will show the following
display:
Door opening (Flashing Display)
Door open
Door closing (Flashing Display)
Closed door
Self Learning
Forced Closing
It signals an alarm and flashes giving the code of the recognised alarm. See
chapter 10
ENGLISH
808-000-000
Sematic Drive System
©
16
w w w. s e m a t i c . c o m
© SEMATIC
z
All rights reserved
Changes can be made without notice
see
www.sematic.com
for latest release
o P
C L
C L
o P
F C
S L
A L