DT-E 1.3: SUN PROTECTION SCREEN – VENETIAN BLINDS C80P and C80L
Issue 3 / April 2017 / EN
page 38 / 62
Fig. 4
8.
Put the bundle of slats with head rail within the
mounting profiles (for convenience of installation put the
bundle at slight angle, so the pins are not damaged)
9.
Lift the bundle to the top to install the head rail in its
brackets. You should pay special attention to properly
insert the pins in cavity of the guide rail (mounted in top
part of the mounting profile).
Picture 7
10.
Loosen the screw in elastic bracket of head rail to easily
open the lock in the bracket.
11.
Insert the bundle in head rail bracket and secure the
bracket.
12.
Connect the motor to the power supply.
Attention:
The bundle should end at the same height as
the mounted top part of the guide rail ends.
Picture 8 and 9
13.
Prepare installation of the remaining section of the guide
rail in the mounting profile (pre-drill holes for tapping
screws to fasten guide rail). Then insert the gaskets into
that section. The gaskets will be longer than the guide
rail (longer with length of cut off section of guide rail).
Picture 10
14.
The extending parts of gaskets insert into previously
mounted guide rail section. Then put the remaining
section of guide rail into mounting profile.
Picture 11 and 12
