DT-E 1.3: SUN PROTECTION SCREEN – VENETIAN BLINDS C80P and C80L
Issue 3 / April 2017 / EN
page 54 / 62
5.
SYSTEM OPERATION AND PRODUCT SAFETY
5.1.
GENERAL SAFETY REQUI REMENTS
During product transport, assembly and disassembly, operation, care and maintenance, suitable regulations of
industrial safety and environmental protection should be observed,
The product should be maintained and repaired solely by the trained and suitably qualified personnel,
The Buyer should make sure that people assigned for carrying out activities connected with current use, cleanness
and maintenance of the product should be familiar with its operating manual and observe the guidelines in all
points of this manual,
Cleaning the product in a way different from the one described in the part entitled
Technical inspections,
maintenance and repairs
is forbidden,
All work must be carried out with due diligence taking into account safety requirements,
Maintenance work and product repairs should be carried out only when the product is disconnected from the
power source,
Markings on the product should be observed (e.g. icons, arrows denoting the direction of motion),
Make sure that markings are not covered with a layer of paint or damaged in a way making it impossible to read
them,
It is forbidden to introduce modification in the electrical design or in the equipment configuration without
consulting the manufacturer or an authorised representative,
Before the product is used, this manual should be read carefully,
The switch should be mounted at the height conforming to the national regulations concerning disabled persons,
not lower than 130cm at best.
5.2.
SAFETY REQUIREMENTS C ONNECTED WITH PARTIC ULAR CONDITIONS AND PLACES OF PRODUCT
USE
Particular safety requirements refer to children at the age of up to 42 months. Particular requirements for use apply to all
places accessible to little children or places where they spend time. Particular requirements for use apply also to all these
places where disabled persons spend time.
Prior to beginning to use the product, the Buyer must carry out individual risk assessment of its use
with particular attention paid to the safety of children and disabled persons.
While determining product operational requirements, it is essential to take into consideration rationally predictable
conditions of use and potential threats.
Do not allow children to play with the control appliances of the roller blind.
Keep the remote control out of the reach of children.
Control the installation frequently for signs of wear of damage to electrical cables. Do not use if repair is
necessary.
